Guide prices
Per standard unit
Flat glass or polycarbonate unit on an existing kerb, as part of a multi-unit job
Per large unit
Larger or ventilating units, edge protection in place
Programme of works
Phased replacement across a building, priced from a survey
Guide ranges for supply & fit, per unit; site set-up priced separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Fitting across Caernarfon and nearby
Distance is rarely the deciding factor. A roof in Bangor, 9 miles from Caernarfon, gets the same survey, the same written quote and the same fitting process as one in LL55, LL61 and LL56. What changes the price is the job itself: size of unit, roof type, access and lifting. Holyhead, around 19 miles out, is treated the same way.
What we do on the day
- Phasing agreed so occupied areas stay dry and usable
- Old units removed, with waste taken off site
- Unit schedule and handover notes for the building's records
- Fire performance near boundaries — We check how close the rooflights are to the site boundary and to escape routes.
- Energy limits for non-domestic roofs — We check new units against the energy limits for non-domestic buildings.
From arrival to clean-up
Protection comes before tools. Floors, furniture and stairs get covered, and the ceiling below the opening is sheeted to catch dust. Up top, the fitters confirm the opening is square and the upstand or flashing suits what the maker specifies. Fixing follows, then weather-sealing into the membrane, felt or tiles. Only once the roof is tight do they turn to the internal reveal. Time on site for a commercial rooflight: about a day per unit, longer on big roofs, weather permitting.
Planning and building rules in Wales
On commercial roofs in Wales, new openings and structural changes go through building control, and fire performance has to be considered where rooflights are near a boundary. Smoke vents must be certified products with controls set up by a specialist. We confirm what applies to your building before quoting.
Before you get in touch
What we cannot see, we have to guess, and guesses make quotes wider. So the more you send, the tighter the price. Useful: shots from the roof or garden, shots from the room underneath, a rough width and length, the roof finish, any access problems, and the product page if you have already ordered. Add the property postcode around LL55 and we will come back with a quote or a survey date.
Common questions in Caernarfon
Do you need scaffolding to fit a rooflight?
Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.
Can you remove and dispose of the old rooflight?
Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.
Will my new commercial rooflight leak?
A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.
Send a few photos and your LL55 postcode, and we will put together a written quote for the job.
