Frameless rooflight installation across Lincolnshire

Guide prices in Lincolnshire

Small frameless

£1,445 – £2,145including VAT at 20%

Up to about 1000 × 1000 mm, hidden frame inside the upstand

Medium frameless

£2,145 – £3,345including VAT at 20%

Up to about 1000 × 2000 mm

Large frameless

£3,345 – £5,395including VAT at 20%

Large single panes, lifting gear on the day

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Lincolnshire

We work right across England, and Lincolnshire is covered on the same footing as everywhere else. There is no showroom or depot to visit. The survey happens at your property or, for fit-only jobs, from your photos. If your address is remote or reached by ferry, tell us early and we will confirm what arrangement is needed before quoting.

Included in the work

Glass bedded on the specified tape or sealant and fixed through the concealed frame
Fall set in the upstand so rain clears the oversailing glass edge
Kerb squared across the diagonals before the glass is ordered or fitted
How the reveal will look — We agree the finish at the glass edge before building anything.
Laminated inner pane — We confirm the inner pane is laminated or otherwise suited to being overhead.

Rules that apply in England

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Common questions in Lincolnshire

Do you make good inside after fitting?

Yes, where the quote includes it. Internal finishing usually means lining the reveal with plasterboard, taping or skimming, and fitting trim where it meets the ceiling. Some people prefer their own plasterer or decorator to finish off, which is fine. The written quote spells out exactly where our work stops, so nobody is left guessing about who does what once the unit is in.

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

Do I need planning permission for a rooflight in Lincolnshire?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

Frameless rooflight installation in Lincolnshire