Guide prices in Essex
Short rigid tube
Around 250 mm tube, short straight run through a loft
Wider or longer run
Around 350 mm tube or longer runs with bends
Flat roof or complex
Flat roof kits, long runs or two tubes
Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Towns we list in Essex
Fitting across Essex means planning routes, access and lifting as well as the roof itself. Narrow lanes, shared driveways and town-centre parking restrictions all affect how a large unit is delivered and raised to roof level. We ask about these early so the quote reflects them. That approach is the same everywhere we work in England, from single domestic jobs to multi-unit commercial sites.
- Sun tunnels in Basildon
- Sun tunnels in Billericay
- Sun tunnels in Braintree
- Sun tunnels in Brentwood
- Sun tunnels in Canvey Island
- Sun tunnels in Chelmsford
- Sun tunnels in Clacton-on-Sea
- Sun tunnels in Colchester
- Sun tunnels in Frinton-on-Sea
- Sun tunnels in Grays
- Sun tunnels in Hadleigh
- Sun tunnels in Harlow
- Sun tunnels in Harwich
- Sun tunnels in Maldon
- Sun tunnels in Pitsea
- Sun tunnels in Rayleigh
- Sun tunnels in Rochford
- Sun tunnels in Saffron Walden
- Sun tunnels in South Benfleet
- Sun tunnels in South Ockendon
- Sun tunnels in Southend-on-Sea
- Sun tunnels in Stanford-le-Hope
- Sun tunnels in Waltham Abbey
- Sun tunnels in Walton-on-the-Naze
- Sun tunnels in Wickford
- Sun tunnels in Witham
Included in the work
- Rigid or flexible tube run and joined, with as few bends as possible
- Route through the loft checked for joists, cables and pipes
- Tube insulated where it passes through a cold loft
- Rigid or flexible tube — We check whether a rigid tube will fit the route before falling back on a flexible one.
- Condensation in cold lofts — We insulate the tube where it passes through a cold loft.
Rules that apply in England
Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.
Common questions in Essex
Do I need planning permission for a rooflight in Essex?
Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.
What if my roof opening is the wrong size for the sun tunnel?
We find out before the fitting day, not on it. If the opening is slightly out, it can usually be adjusted by trimming or by packing out the upstand. If it is a long way off, the choice is between altering the opening and changing the unit. Bear in mind that rooflights are often sold by builder's opening size rather than external size, so check which one your measurement refers to.
Do you offer trade rates for builders and roofers?
We carry out subcontract fitting for builders, roofers, extension companies and commercial contractors. Pricing is per job or per schedule of units, agreed in writing before we start. We can work to your programme, fit on your upstand or build our own, and leave the opening ready for the next trade. Send drawings or a unit schedule and we will come back with a trade quote.

