Guide prices in Kenilworth
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Is your address covered?
Jobs across CV8, CV32 and CV34 are part of our normal cover for Kenilworth. We are not an office on the high street. Our fitting teams come out to the property from wherever they are working that week. Neighbouring places such as Warwick and Coventry are covered on the same terms, so a house on the edge of town is no harder to book than one in the centre.
What we do on the day
- Rotten kerb sections replaced where the timber has gone soft
- Membrane splits at the upstand cut back and patched
- Inside check of stains, frame drainage channels and the reveal
- Upstand height and condition — We measure the kerb and probe the timber for softness.
- Warranty and who fitted it — We ask who fitted the rooflight and when before working on it.
How a repair visit goes
Expect the visit to be mostly looking and testing. Dust sheets go down below the rooflight. The fitter checks seals and glass from inside, then gets up on the roof by ladder or tower. Minor jobs such as clearing a blocked drainage channel can often be dealt with there and then. Bigger work, like new flashing or a replacement sealed unit, is measured up and priced in writing afterwards.
Do you need permission in Kenilworth?
In England, a new rooflight opening generally needs building regulations approval because the roof structure is altered and the glazing must meet energy rules: 2.2 W/m²K for a rooflight in an existing home, or 1.4 W/m²K (or WER Band B) for a roof window. Planning is often not needed on a house: permitted development covers rooflights that stand no more than 0.15 m proud of the roof slope and sit below the highest part of the roof. Flats, listed buildings and areas with an Article 4 direction are different, so we check your address first.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Kenilworth
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
Do you charge for a leak investigation in Kenilworth?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
Got a leak or a misted unit in Kenilworth? Send photos first and we will tell you what the visit costs before booking.
