Rooflight installers in Kenilworth

Fitting jobs in Kenilworth

The details a specialist gets right

Builders run many trades at once, and the rooflight often gets squeezed in between the roofer and the plasterer. That is when corners get cut: an upstand built a little low, sealant applied in damp conditions, a reveal left rough. Bringing in a fitting specialist for that one stage means someone is focused on it alone, following the maker's instructions, with time set aside to finish the inside properly. The builder keeps control of the programme, and the rooflight gets proper attention.

Postcodes and places we cover

Postcodes CV8, CV32 and CV34 are the core of our Kenilworth coverage, but they are not the boundary. Addresses in Warwick, Coventry and Leamington Spa are handled in just the same way, with fitters travelling to each one and travel costs built into the quote before you agree to anything. If you are unsure which side of a boundary you fall on, the full postcode settles it.

Planning and building control

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Questions about rooflight fitting in Kenilworth

How long does fitting take?

Fitting a rooflight into an existing, correctly sized opening is often a day's work. New openings take longer, because joists or rafters need trimming, an upstand or flashing has to be built or fitted, and the inside needs finishing. Large units that need lifting gear, and days lost to rain, can stretch things further. Your written quote gives a realistic estimate for your roof.

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

What upstand height and roof pitch does rooflight fitting need?

It depends on the product. Manufacturers usually specify a minimum upstand height above the finished roof surface, and a minimum pitch on the glass so rain runs off. We follow the maker's figures for your unit rather than a rule of thumb. If your existing kerb or roof falls short, we explain the options, such as raising the upstand or choosing a unit with built-in pitch.

Do I need planning permission for a rooflight in Kenilworth?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

Fitting jobs in Kenilworth

Fitting & replacement

Flat roof rooflights

Pitched roofs & lofts

Commercial & trade

The details a specialist gets right

Postcodes and places we cover

Planning and building control

Questions about rooflight fitting in Kenilworth

Rooflight fitting in Kenilworth