Guide prices in Bedworth
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Where our fitters travel
Distance is rarely the deciding factor. A roof in Nuneaton, 3 miles from Bedworth, gets the same survey, the same written quote and the same fitting process as one in CV12, CV11 and CV10. What changes the price is the job itself: size of unit, roof type, access and lifting. Coventry, around 5 miles out, is treated the same way.
What the job includes
- Failed sealant cut out, joints cleaned, dried and resealed
- Rotten kerb sections replaced where the timber has gone soft
- Lifted flashing or tape removed and renewed
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
- Upstand height and condition — We measure the kerb and probe the timber for softness.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Planning and building rules in England
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Bedworth
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Do you charge for a leak investigation in Bedworth?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
Send photos of the problem in Bedworth and we will price the visit before you book it.
