What the job costs in Braunstone
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Fitting across Braunstone and nearby
Braunstone and the districts around it, LE3, LE1 and LE2, all sit inside our working area. So does the ground between Braunstone and Glen Parva (2 miles), and on towards Leicester (2 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
On the day, we cover
- Lifted flashing or tape removed and renewed
- Membrane splits at the upstand cut back and patched
- Rotten kerb sections replaced where the timber has gone soft
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
- Upstand height and condition — We measure the kerb and probe the timber for softness.
How a repair visit goes
On arrival we agree access and protect the floor. Then a methodical check: glass for misting or cracks, seals for gaps, the frame for movement, the upstand and roof covering for splits or water lying against the kerb. If the cause is obvious and minor, it can usually be sorted as part of the visit. If not, you have the evidence and a priced repair plan, and the choice is yours.
Planning, building control and Braunstone
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Photos help us price the visit. Send one of the stain or drip inside, one of the rooflight from outside if you can reach a safe viewpoint, and a note of when it leaks: in heavy rain, in wind, or all the time. Add the postcode, LE3 or similar, and how the roof is reached.
Common questions in Braunstone
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
For a repair in Braunstone, start with photos and the postcode; we confirm the visit price before anything is booked.
