What the job costs in Tadley
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Covering RG26 and neighbouring districts
Tadley and the districts around it, RG26, RG24 and RG21, all sit inside our working area. So does the ground between Tadley and Basingstoke (6 miles), and on towards Thatcham (7 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
What we do on the day
- Failed sealant cut out, joints cleaned, dried and resealed
- Membrane splits at the upstand cut back and patched
- Rotten kerb sections replaced where the timber has gone soft
- Water lying against the kerb — We check whether rainwater sits against the upstand after it stops raining.
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Planning and building rules in England
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Tadley
Will resealing fix my leaking rooflight?
Sometimes. If the sealant has simply aged and the flashing, upstand and glass are sound, a careful reseal on a dry day can solve it. If the real problem is ponding water, a low upstand or a perished membrane, fresh sealant will only hide it for a while. We tell you which one you are dealing with before recommending any work, and quote the proper fix in writing.
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
For a repair in Tadley, start with photos and the postcode; we confirm the visit price before anything is booked.
