What the job costs in Reading
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Is your address covered?
Fitters travel to the job, so the address is what counts. In Reading that means postcode districts RG1, RG4 and RG30, and the same teams can just as easily take on work in Lower Earley, about 3 miles away, or Wokingham at roughly 7 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.
On the day, we cover
- Inside check of stains, frame drainage channels and the reveal
- Membrane splits at the upstand cut back and patched
- Controlled water test where it helps pin down the entry point
- Upstand height and condition — We measure the kerb and probe the timber for softness.
- Leak or condensation — We work out whether the water is coming from outside or forming inside on cold glass.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Planning, building control and Reading
England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.
What to send us
Before booking a visit, send what you can: a photo of the ceiling or reveal where water shows, a photo of the rooflight from outside, the roof covering if you know it, and whether it is one rooflight or several. We use that to price the visit and to bring the right materials.
Common questions in Reading
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
Do you charge for a leak investigation in Reading?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
For a repair in Reading, start with photos and the postcode; we confirm the visit price before anything is booked.
