Brixton guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Is your address covered?
Fitters travel to the job, so the address is what counts. In Brixton that means postcode districts SW9, SE5 and SE24, and the same teams can just as easily take on work in Camberwell, about 1 mile away, or Clapham at roughly 1 mile. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.
Included in the work
- Rotten kerb sections replaced where the timber has gone soft
- Membrane splits at the upstand cut back and patched
- Failed sealant cut out, joints cleaned, dried and resealed
- Upstand height and condition — We measure the kerb and probe the timber for softness.
- Water lying against the kerb — We check whether rainwater sits against the upstand after it stops raining.
How a repair visit goes
Expect the visit to be mostly looking and testing. Dust sheets go down below the rooflight. The fitter checks seals and glass from inside, then gets up on the roof by ladder or tower. Minor jobs such as clearing a blocked drainage channel can often be dealt with there and then. Bigger work, like new flashing or a replacement sealed unit, is measured up and priced in writing afterwards.
Planning, building control and Brixton
Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Brixton
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
For a repair in Brixton, start with photos and the postcode; we confirm the visit price before anything is booked.
