Frameless rooflight installation across Bedfordshire

Guide prices in Bedfordshire

Small frameless

£1,445 – £2,145including VAT at 20%

Up to about 1000 × 1000 mm, hidden frame inside the upstand

Medium frameless

£2,145 – £3,345including VAT at 20%

Up to about 1000 × 2000 mm

Large frameless

£3,345 – £5,395including VAT at 20%

Large single panes, lifting gear on the day

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Bedfordshire

We work right across England, and Bedfordshire is covered on the same footing as everywhere else. There is no showroom or depot to visit. The survey happens at your property or, for fit-only jobs, from your photos. If your address is remote or reached by ferry, tell us early and we will confirm what arrangement is needed before quoting.

Included in the work

Glass bedded on the specified tape or sealant and fixed through the concealed frame
Lifting gear arranged for heavy single panes where two people cannot safely carry
Fall set in the upstand so rain clears the oversailing glass edge
Drainage at the overhang — We check how water leaves the glass where it oversails the kerb.
How the reveal will look — We agree the finish at the glass edge before building anything.

Rules that apply in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Common questions in Bedfordshire

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

How long does fitting take?

Fitting a frameless rooflight into an existing, correctly sized opening is often a day's work. New openings take longer, because joists or rafters need trimming, an upstand or flashing has to be built or fitted, and the inside needs finishing. Large units that need lifting gear, and days lost to rain, can stretch things further. Your written quote gives a realistic estimate for your roof.

Do you need scaffolding to fit a rooflight?

Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.

Frameless rooflight installation in Bedfordshire