Electric opening rooflight installation across Buckinghamshire

Guide prices in Buckinghamshire

Small opening

£2,645 – £3,595including VAT at 20%

Up to about 1000 × 1000 mm with actuator, rain sensor and switch or remote

Medium opening

£3,595 – £4,795including VAT at 20%

Larger units, wall switch and remote

Large opening

£4,795 – £6,945including VAT at 20%

Big or heavy units, extra actuators

Guide ranges for supply & fit; the electrician's final connection is quoted separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Buckinghamshire

We work right across England, and Buckinghamshire is covered on the same footing as everywhere else. There is no showroom or depot to visit. The survey happens at your property or, for fit-only jobs, from your photos. If your address is remote or reached by ferry, tell us early and we will confirm what arrangement is needed before quoting.

What's included

Wall switch, remote receiver or control box fixed in place
Cable route and controls set up ready for the electrician's final connection, quoted as a separate line
Opening and closing tested, with controls explained at handover
Opening onto a side slope — We check where the opening part will sit if the roof is pitched or the unit faces a neighbour.
Rain sensor position — We place the rain sensor where rain will reach it quickly and debris will not cover it.

Rules that apply in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Common questions in Buckinghamshire

What if my roof opening is the wrong size for the electric opening rooflight?

We find out before the fitting day, not on it. If the opening is slightly out, it can usually be adjusted by trimming or by packing out the upstand. If it is a long way off, the choice is between altering the opening and changing the unit. Bear in mind that rooflights are often sold by builder's opening size rather than external size, so check which one your measurement refers to.

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

Will my new electric opening rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

Electric opening rooflight installation in Buckinghamshire