Guide prices in Worcestershire
Per standard unit
Flat glass or polycarbonate unit on an existing kerb, as part of a multi-unit job
Per large unit
Larger or ventilating units, edge protection in place
Programme of works
Phased replacement across a building, priced from a survey
Guide ranges for supply & fit, per unit; site set-up priced separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Towns we list in Worcestershire
We work right across England, and Worcestershire is covered on the same footing as everywhere else. There is no showroom or depot to visit. The survey happens at your property or, for fit-only jobs, from your photos. If your address is remote or reached by ferry, tell us early and we will confirm what arrangement is needed before quoting.
- Commercial rooflights in Bromsgrove
- Commercial rooflights in Droitwich
- Commercial rooflights in Evesham
- Commercial rooflights in Great Malvern
- Commercial rooflights in Kidderminster
- Commercial rooflights in Redditch
- Commercial rooflights in Stourport-on-Severn
- Commercial rooflights in Worcester
What the job includes
- Phasing agreed so occupied areas stay dry and usable
- Kerbs checked and packed, adapted or rebuilt where needed
- Roof survey of every unit, kerb and the fragile areas around them
- Working around occupied buildings — We plan noise, dust and access around the people using the building.
- Fragile roofs and rooflights — We treat every rooflight and the roof around it as fragile until we have checked it.
Rules that apply in England
On commercial buildings in England, new rooflights and changes to roof structure go through building control, and replacements in non-dwellings also need building control involvement unless fitted by a scheme-registered installer, which we are not; load-bearing or structural glass always goes through building control. Fire rules matter near boundaries and over escape routes, and smoke vents must be certified to BS EN 12101-2. We confirm the route and the paperwork for your building before work starts.
Common questions in Worcestershire
What upstand height and roof pitch does commercial rooflight fitting need?
It depends on the product. Manufacturers usually specify a minimum upstand height above the finished roof surface, and a minimum pitch on the glass so rain runs off. We follow the maker's figures for your unit rather than a rule of thumb. If your existing kerb or roof falls short, we explain the options, such as raising the upstand or choosing a unit with built-in pitch.
Do you cover Worcestershire?
Yes. Fitters travel to addresses in Worcestershire and the surrounding districts, including B, DY and WR postcodes. We do not run an office there; the survey and the fitting happen at your property. A few island and remote postcodes are covered by arrangement; if yours is one, we confirm travel and dates before quoting.
Will my new commercial rooflight leak?
A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.
