Trade rooflight fitting across East Sussex

Guide prices in East Sussex

Per flat rooflight

£295 – £495plus VAT, trade rate

Fit a supplied unit to your prepared upstand, sealed and trimmed

Per roof lantern

£695 – £1,495plus VAT, trade rate

Assemble and glaze a supplied lantern on your upstand

Two-person day rate

£445 – £645plus VAT, trade rate

Fitting team for multi-unit or mixed work

Guide ranges for labour only, ex VAT for trade accounts. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in East Sussex

We work right across England, and East Sussex is covered on the same footing as everywhere else. There is no showroom or depot to visit. The survey happens at your property or, for fit-only jobs, from your photos. If your address is remote or reached by ferry, tell us early and we will confirm what arrangement is needed before quoting.

Included in the work

Roof lanterns assembled and glazed on your upstand
Supplied units checked against your schedule before fitting
Flat rooflights fitted, sealed and trimmed on your kerbs
Programme and access — We confirm site access, lifting arrangements and working hours before the visit.
Upstand ready and to size — We ask for the upstands to be built to the maker's drawing before we arrive.

Rules that apply in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so on trade replacements we agree up front who notifies building control, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Common questions in East Sussex

Who deals with building control on trade jobs?

On new-build and extension work the rooflights usually sit within your approval or warrant. On replacements in homes in England and Wales we agree up front who notifies building control; we are not registered with a competent person scheme, so we cannot self-certify.

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

What if my roof opening is the wrong size for the rooflight?

We find out before the fitting day, not on it. If the opening is slightly out, it can usually be adjusted by trimming or by packing out the upstand. If it is a long way off, the choice is between altering the opening and changing the unit. Bear in mind that rooflights are often sold by builder's opening size rather than external size, so check which one your measurement refers to.

Trade rooflight fitting in East Sussex