What the job costs in Wellington
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Coverage in and around Wellington
Wellington and the districts around it, TF1, TF5 and TF6, all sit inside our working area. So does the ground between Wellington and Telford (3 miles), and on towards Shrewsbury (10 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
What we do on the day
- Failed sealant cut out, joints cleaned, dried and resealed
- Lifted flashing or tape removed and renewed
- Membrane splits at the upstand cut back and patched
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
- Water lying against the kerb — We check whether rainwater sits against the upstand after it stops raining.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Do you need permission in Wellington?
Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.
What to send us
Before booking a visit, send what you can: a photo of the ceiling or reveal where water shows, a photo of the rooflight from outside, the roof covering if you know it, and whether it is one rooflight or several. We use that to price the visit and to bring the right materials.
Common questions in Wellington
Do you charge for a leak investigation in Wellington?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Will resealing fix my leaking rooflight?
Sometimes. If the sealant has simply aged and the flashing, upstand and glass are sound, a careful reseal on a dry day can solve it. If the real problem is ponding water, a low upstand or a perished membrane, fresh sealant will only hide it for a while. We tell you which one you are dealing with before recommending any work, and quote the proper fix in writing.
Got a leak or a misted unit in Wellington? Send photos first and we will tell you what the visit costs before booking.
