Guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Areas around Sandown we cover
Distance is rarely the deciding factor. A roof in Ryde, 5 miles from Sandown, gets the same survey, the same written quote and the same fitting process as one in PO36, PO37 and PO35. What changes the price is the job itself: size of unit, roof type, access and lifting. Newport, around 7 miles out, is treated the same way.
What the job includes
- Rotten kerb sections replaced where the timber has gone soft
- Lifted flashing or tape removed and renewed
- Controlled water test where it helps pin down the entry point
- Leak or condensation — We work out whether the water is coming from outside or forming inside on cold glass.
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Planning, building control and Sandown
Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Sandown
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
For a repair in Sandown, start with photos and the postcode; we confirm the visit price before anything is booked.
