Roof access hatch installation in Richmond

What the job costs in Richmond

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Fitting across Richmond and nearby

Fitters travel to the job, so the address is what counts. In Richmond that means postcode districts TW9, TW10 and TW1, and the same teams can just as easily take on work in Twickenham, about 1 mile away, or Isleworth at roughly 2 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.

Your roof access hatches or ours

There are two ways to do this. Supply and fit means we source a roof access hatch that suits your roof and install it, so one company answers for both the product choice and the fitting. Fit-only means you buy the unit and we install it. With fit-only, the product warranty stays with the maker or seller, and our written guarantee covers the fitting work. Both routes get the same checks on the opening, the upstand and the maker's instructions before anything is fixed.

What we do on the day

• Electric hatches wired ready for the electrician's final connection, quoted separately
• Opening and closing tested and the controls explained
• Kerb checked or built square, level and to the maker's height
• Access hatch or smoke vent — We confirm the hatch is only for access and not part of a building's smoke ventilation.
• Energy performance of hatches — We check the hatch's published U-value against the limit that applies.

From arrival to clean-up

Morning first: the team arrives, introduces itself and walks through the job with you. Dust sheets go down in the room below and along the route in. Then the opening and upstand, or the flashing on a pitched roof, are checked against the unit's measurements. A roof access hatch goes in, is fixed to the maker's pattern and sealed into the roof covering. Inside, the reveal is finished as quoted. Before leaving, the team clears debris and talks you through what was done. Most jobs of this type take one day.

Do you need permission in Richmond?

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Details that speed up your quote

Keep it simple. Two or three photos, outside and inside. Approximate sizes. What the roof is made of. Anything awkward about getting up there, such as a conservatory below, a narrow side path or no parking. If you bought the rooflight online, the link or model name. Then your postcode in or around TW9. That is enough for a first price.

Common questions in Richmond

Planning a roof access hatch in Richmond? Tell us about the roof and we will come back with a clear price in writing.