Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Somerset · England

Frameless rooflight installation in Somerset

A good share of frameless rooflight installation in Somerset is replacement work. Older units go brittle or discoloured, sealed glass mists, and seals give up after years of sun and frost. Swapping the unit is often possible on the existing kerb, provided that kerb is sound, level and tall enough above the finished roof. Where it is not, we rebuild it. We cover the whole of Somerset, across 55 postcode districts, with fitters travelling to each address.

Guide prices in Somerset

Small frameless

£1,445 – £2,145including VAT at 20%

Up to about 1000 × 1000 mm, hidden frame inside the upstand

Medium frameless

£2,145 – £3,345including VAT at 20%

Up to about 1000 × 2000 mm

Large frameless

£3,345 – £5,395including VAT at 20%

Large single panes, lifting gear on the day

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Somerset

Somerset is part of our normal coverage in England. Fitting teams travel out to the property, so a town-centre terrace and a house down a farm track are treated alike, as long as a fitter can get the unit to the roof safely. Dates are offered according to fitter availability, and the cost of travel is already in your written quote.

What we do on the day

  • Inside reveal formed so plaster or trim meets the glass cleanly
  • Upstand built to the maker's drawing within its stated tolerance
  • Glass bedded on the specified tape or sealant and fixed through the concealed frame
  • How the reveal will look — We agree the finish at the glass edge before building anything.
  • Drainage at the overhang — We check how water leaves the glass where it oversails the kerb.

Rules that apply in England

Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.

Common questions in Somerset

Will my new frameless rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

Do I need planning permission for a rooflight in Somerset?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Fitting in Somerset

Send photos and rough sizes, or ask for a survey visit for install work. You get one fixed written price before anything starts.

CallGet a quote