Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Newport · PO30 · Isle of Wight

Dome rooflight replacement in Newport

Dome rooflight replacement in Newport comes down to what happens around the glass. A good unit sat on a poor upstand, or with the membrane or flashing cut short at the corners, will still let water in. We fit each dome rooflight to the maker's instructions for fixings, packers and sealant, for homes and businesses across Newport and the rest of Isle of Wight. That covers supply and fit, fit-only for a unit you already own, and swapping out a tired one. Every job starts with a written quote, so the price and scope are clear before anyone climbs a ladder.

Guide price from £395 · Supply & fit, per dome; building control notice fee extra on homes in England and Wales

What the job costs in Newport

Like-for-like dome

£395 – £695including VAT at 20%

Old dome taken off, new multi-skin dome fixed to the sound existing kerb

Dome with kerb adaptor

£695 – £1,195including VAT at 20%

New dome where the kerb needs an adaptor or packing

Upgrade to glass

£1,095 – £1,695including VAT at 20%

Dome swapped for a double-glazed glass rooflight on the existing sound kerb, as in our replacement service

Guide ranges for supply & fit, per dome; building control notice fee extra on homes in England and Wales. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Is your address covered?

Newport and the districts around it, PO30, PO32 and PO31, all sit inside our working area. So does the ground between Newport and Cowes (4 miles), and on towards Ryde (6 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.

Buying your own, or letting us supply

Which works out better, buying your own or letting us supply? It depends on what you value. Buying your own gives you control of the product and what you pay for it. Letting us supply puts the whole job, unit and fitting, under one written quote. On a customer-supplied unit we still measure it against the opening, look at the upstand, and inspect the condition it arrived in. Warranty on the product sits with whoever sold it, while the fitting carries our own guarantee.

Included in the work

  • New multi-skin dome or glass unit fixed and sealed
  • Membrane checked where it meets the kerb, with small repairs made
  • Adaptor or packing fitted where the old kerb needs it
  • Kerb size and adaptors — We measure every kerb against the new dome's sizes.
  • Upgrading to glass — We check whether the kerb suits a glass unit before recommending one.

How a fitting day runs

Fitting days start with a look at the sky. If rain is due, the order of work changes so the roof is never left open to it. A typical day for a dome rooflight runs like this: set up access, protect the room, open up the roof or prepare the existing kerb or frame, check sizes, fix, seal, then finish inside. On jobs that take more than a day, the opening is weather-sealed overnight. The last hour goes on tidying, waste removal and a walk-round with you.

Do you need permission in Newport?

Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.

Details that speed up your quote

For fit-only work, the product details matter most: the link, the spec sheet, or a photo of the label on the box. Alongside that, send pictures of the roof and the ceiling below, approximate opening sizes, the type of roof covering, and how someone would get onto the roof. For supply and fit, the same photos and sizes do the job. Finish with your postcode, such as PO30.

Common questions in Newport

What upstand height and roof pitch does dome rooflight fitting need?

It depends on the product. Manufacturers usually specify a minimum upstand height above the finished roof surface, and a minimum pitch on the glass so rain runs off. We follow the maker's figures for your unit rather than a rule of thumb. If your existing kerb or roof falls short, we explain the options, such as raising the upstand or choosing a unit with built-in pitch.

Does a rooflight need building regulations approval?

A new opening usually needs building regulations approval. A replacement is a controlled fitting: it must be self-certified by an installer registered with a competent person scheme or notified to building control. We are not registered with a scheme, so replacements we fit are notified to building control with a building notice, and the council's fee is shown on your quote.

Do I need planning permission for a rooflight in Newport?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

Get in touch with the details of your Newport property and we will explain what the job involves and what it costs.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Dome replacement in Newport

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote