Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Evesham · WR11 · Worcestershire

Conservation rooflight installation in Evesham

Conservation rooflight installation in Evesham comes down to what happens around the glass. A good unit sat on a poor upstand, or with the membrane or flashing cut short at the corners, will still let water in. We fit each conservation rooflight to the maker's instructions for fixings, packers and sealant, for homes and businesses across Evesham and the rest of Worcestershire. That covers supply and fit, fit-only for a unit you already own, and swapping out a tired one. Every job starts with a written quote, so the price and scope are clear before anyone climbs a ladder.

Guide price from £1,145 · Supply & fit

Evesham guide prices

Small conservation unit

£1,145 – £1,695including VAT at 20%

Low-profile unit with glazing bar, slate or tile flashing

Medium unit

£1,695 – £2,495including VAT at 20%

Larger opening, lead or matching flashings

Large or bespoke

£2,495 – £3,845including VAT at 20%

Larger or made-to-order units for listed or sensitive roofs

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Fitting across Evesham and nearby

Fitters travel to the job, so the address is what counts. In Evesham that means postcode districts WR11, WR12 and WR10, and the same teams can just as easily take on work in Tewkesbury, about 11 miles away, or Stratford-upon-Avon at roughly 12 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.

Fit-only or supply and fit

There are two ways to do this. Supply and fit means we source a conservation rooflight that suits your roof and install it, so one company answers for both the product choice and the fitting. Fit-only means you buy the unit and we install it. With fit-only, the product warranty stays with the maker or seller, and our written guarantee covers the fitting work. Both routes get the same checks on the opening, the upstand and the maker's instructions before anything is fixed.

What the job includes

  • Slates or tiles made good around the frame with tidy cuts
  • Slates or tiles lifted carefully and kept for reuse where possible
  • Position checked against any consent drawings or council conditions
  • Energy and old roofs — We make sure the rooflight meets current energy rules while suiting an older roof build-up.
  • Listed building consent — We confirm listed building consent is in place before fitting any rooflight on a listed building.

Fitting your conservation rooflight, step by step

Morning first: the team arrives, introduces itself and walks through the job with you. Dust sheets go down in the room below and along the route in. Then the opening and upstand, or the flashing on a pitched roof, are checked against the unit's measurements. A conservation rooflight goes in, is fixed to the maker's pattern and sealed into the roof covering. Inside, the reveal is finished as quoted. Before leaving, the team clears debris and talks you through what was done. Most jobs of this type take one day.

Planning, building control and Evesham

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

What to send for a quick quote

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in WR11, and we can price it.

Common questions in Evesham

Do you need scaffolding to fit a rooflight?

Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.

Do you cover Evesham?

Yes. Fitters travel to addresses in Evesham and the surrounding districts, including WR11. We do not run an office there; the survey and the fitting happen at your property. A few island and remote postcodes are covered by arrangement; if yours is one, we confirm travel and dates before quoting.

Can you fit the conservation rooflight I bought online?

Yes, fit-only is one of our core services. Send the product link or spec, photos of the roof and rough sizes, and we can usually price it from those. Before fitting we check the delivery for damage, which should be reported to the seller, plus the size against the opening, the flashing kit and the roof pitch. The product warranty stays with the maker or seller, and our guarantee covers the fitting.

Got a unit waiting to go in, or need one sourced? Either way, start with your Evesham address and a couple of photos.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Conservation rooflights in Evesham

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote