Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Acocks Green · B27 · West Midlands

Conservation rooflight installation in Acocks Green

Builders and extension firms in Acocks Green often want the rooflight stage of a project handled by a specialist fitting team. We step in once the roof deck or battens are ready, fit a conservation rooflight on your upstand or ours, detail it into the membrane or tiles, and leave the opening ready for the plasterer. Homeowners get exactly the same service directly. In each case the job is quoted in writing first, with any access or lifting needs spelt out. Jobs around B27 and the neighbouring districts are welcome.

Guide price from £1,145 · Supply & fit

What the job costs in Acocks Green

Small conservation unit

£1,145 – £1,695including VAT at 20%

Low-profile unit with glazing bar, slate or tile flashing

Medium unit

£1,695 – £2,495including VAT at 20%

Larger opening, lead or matching flashings

Large or bespoke

£2,495 – £3,845including VAT at 20%

Larger or made-to-order units for listed or sensitive roofs

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Fitting across Acocks Green and nearby

Acocks Green and the districts around it, B27, B25 and B26, all sit inside our working area. So does the ground between Acocks Green and Shirley (3 miles), and on towards Solihull (3 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.

Already bought your unit?

There are two ways to do this. Supply and fit means we source a conservation rooflight that suits your roof and install it, so one company answers for both the product choice and the fitting. Fit-only means you buy the unit and we install it. With fit-only, the product warranty stays with the maker or seller, and our written guarantee covers the fitting work. Both routes get the same checks on the opening, the upstand and the maker's instructions before anything is fixed.

What we do on the day

  • Slates or tiles made good around the frame with tidy cuts
  • Rooflight set low so it sits close to the line of the roof
  • Slates or tiles lifted carefully and kept for reuse where possible
  • Reusing the original covering — We plan to reuse the existing slates or tiles wherever we can.
  • Conservation area rules by nation — We check the permitted development position for your nation before the rooflight is ordered.

From arrival to clean-up

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix a conservation rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Planning and building rules in England

Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.

Help us quote accurately

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in B27, and we can price it.

Common questions in Acocks Green

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

Do you need scaffolding to fit a rooflight?

Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.

Do I need planning permission for a rooflight in Acocks Green?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

For a free, no-obligation quote in Acocks Green, use the form or call us with the details of your roof.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Conservation rooflights in Acocks Green

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote