Guide prices in County Durham
Per standard unit
Flat glass or polycarbonate unit on an existing kerb, as part of a multi-unit job
Per large unit
Larger or ventilating units, edge protection in place
Programme of works
Phased replacement across a building, priced from a survey
Guide ranges for supply & fit, per unit; site set-up priced separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Towns we list in County Durham
Fitting across County Durham means planning routes, access and lifting as well as the roof itself. Narrow lanes, shared driveways and town-centre parking restrictions all affect how a large unit is delivered and raised to roof level. We ask about these early so the quote reflects them. That approach is the same everywhere we work in England, from single domestic jobs to multi-unit commercial sites.
- Commercial rooflights in Billingham
- Commercial rooflights in Bishop Auckland
- Commercial rooflights in Chester-le-Street
- Commercial rooflights in Consett
- Commercial rooflights in Darlington
- Commercial rooflights in Durham
- Commercial rooflights in Hartlepool
- Commercial rooflights in Newton Aycliffe
- Commercial rooflights in Peterlee
- Commercial rooflights in Seaham
- Commercial rooflights in Spennymoor
- Commercial rooflights in Stanley
- Commercial rooflights in Stockton-on-Tees
- Commercial rooflights in Thornaby-on-Tees
- Commercial rooflights in Yarm
Included in the work
- Kerbs checked and packed, adapted or rebuilt where needed
- Old units removed, with waste taken off site
- Access, edge protection and fragile-roof covers planned before work starts
- Glass or polycarbonate — We compare glass and polycarbonate units against the roof, use and budget.
- Fire performance near boundaries — We check how close the rooflights are to the site boundary and to escape routes.
Rules that apply in England
On commercial buildings in England, new rooflights and changes to roof structure go through building control, and replacements in non-dwellings also need building control involvement unless fitted by a scheme-registered installer, which we are not; load-bearing or structural glass always goes through building control. Fire rules matter near boundaries and over escape routes, and smoke vents must be certified to BS EN 12101-2. We confirm the route and the paperwork for your building before work starts.
Common questions in County Durham
Does commercial rooflight work need building control?
Usually. New openings, structural changes and smoke vents go through building control, and on buildings covered by fire safety law that means a full plans application rather than a building notice. We are not registered with a competent person scheme, so replacements we fit are notified to building control. We confirm the route and show any fee on the quote.
Do commercial rooflights need planning permission?
Like-for-like replacements on commercial buildings rarely need planning permission. New or larger rooflights on non-domestic buildings and blocks of flats usually need checking with the planning authority, because householder permitted development rights don't apply. We tell you what we know about your building and point you to the right team.
Who is responsible for the smoke-control system?
The building's responsible person, duty holder or managing agent, depending on the nation, is responsible for keeping fire safety systems working. Our part is the rooflight and roof work; the controls, detection and commissioning are handled by a smoke-control specialist, and the quote says who does what.

