What the job costs in Ballymena
Per standard unit
Flat glass or polycarbonate unit on an existing kerb, as part of a multi-unit job
Per large unit
Larger or ventilating units, edge protection in place
Programme of works
Phased replacement across a building, priced from a survey
Guide ranges for supply & fit, per unit; site set-up priced separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Coverage in and around Ballymena
Fitters travel to the job, so the address is what counts. In Ballymena that means postcode districts BT42, BT43 and BT44, and the same teams can just as easily take on work in Antrim, about 10 miles away, or Larne at roughly 18 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.
What we do on the day
- New units fitted, sealed and weathered into the roof covering
- Unit schedule and handover notes for the building's records
- Phasing agreed so occupied areas stay dry and usable
- Fragile roofs and rooflights — We treat every rooflight and the roof around it as fragile until we have checked it.
- Energy limits for non-domestic roofs — We check new units against the energy limits for non-domestic buildings.
From arrival to clean-up
Arrive and agree the plan. Sheet the floor and furniture. Set up the ladder, tower or scaffold. Check the opening, the upstand or flashing, and the unit against the paperwork. Fix and pack a commercial rooflight level. Seal it into the roof. Line the reveal or fit the ceiling trim. Clean the glass, clear the waste, and talk you through it. That is the shape of most fitting days, and for this type of job it usually takes about a day per unit, longer on big roofs.
Planning, building control and Ballymena
On commercial buildings in Northern Ireland, rooflight openings and roof alterations go through building control, with energy and fire requirements for the glazing set out in the Technical Booklets. Smoke vents must be certified products with controls commissioned by a specialist. We confirm the route for your building.
Help us quote accurately
Each detail you send takes a question off our list. Photos inside and out show the opening and the ceiling. Rough measurements tell us the unit size. The roof covering tells us how it will be sealed in. Access notes tell us whether a tower or scaffold is needed. A product link, if you have one, lets us check it against the opening. Your postcode, BT42 or nearby, confirms travel.
Common questions in Ballymena
Will my new commercial rooflight leak?
A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.
Do you need scaffolding to fit a rooflight?
Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.
Do you cover Ballymena?
Yes. Fitters travel to addresses in Ballymena and the surrounding districts, including BT42. We do not run an office there; the survey and the fitting happen at your property. A few island and remote postcodes are covered by arrangement; if yours is one, we confirm travel and dates before quoting.
Send a few photos and your BT42 postcode, and we will put together a written quote for the job.
