Rooflight installers in Burntwood

Fitting jobs in Burntwood

Where rooflight jobs go wrong

The joint between the rooflight and the roof covering is where most leaks start. On a flat roof that means turning the membrane up the kerb and terminating it properly under the frame. On a pitched roof it means the right flashing kit, lapped correctly with the tiles or slates. These details are fiddly and easy to rush on a busy build. Giving them to someone focused on fitting the rooflight, rather than treating it as one task among dozens, cuts the chance of a callback.

Is your Burntwood address covered?

Covering Burntwood properly means covering the whole of it, house or business unit, across WS7, WS12 and WS11. Beyond the town, we take on jobs in Great Wyrley (4 miles) and Lichfield (4 miles) as standard. Each one gets the same survey or photo-based pricing, the same written quote, and the same fitting standard.

Planning and building control

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Questions about rooflight fitting in Burntwood

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

What upstand height and roof pitch does rooflight fitting need?

It depends on the product. Manufacturers usually specify a minimum upstand height above the finished roof surface, and a minimum pitch on the glass so rain runs off. We follow the maker's figures for your unit rather than a rule of thumb. If your existing kerb or roof falls short, we explain the options, such as raising the upstand or choosing a unit with built-in pitch.

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Do you cover Burntwood?

Yes. Fitters travel to addresses in Burntwood and the surrounding districts, including WS7. We do not run an office there; the survey and the fitting happen at your property. A few island and remote postcodes are covered by arrangement; if yours is one, we confirm travel and dates before quoting.

Fitting jobs in Burntwood

Fitting & replacement

Flat roof rooflights

Pitched roofs & lofts

Commercial & trade

Where rooflight jobs go wrong

Is your Burntwood address covered?

Planning and building control

Questions about rooflight fitting in Burntwood

Rooflight fitting in Burntwood