Rooflight installers in Hitchin

Fitting jobs in Hitchin

Why the fitting matters as much as the unit

A general builder can frame an opening perfectly well. The trouble usually comes at the top of it. Rooflight makers specify a minimum upstand height above the finished roof, a minimum pitch on the glass, and particular fixings and packers. Miss one of those and the unit can hold water, leak at the corners, or put its product warranty at risk. A fitting specialist works to those figures and checks where each maker's instructions differ. That is the part of the job worth handing over.

Fitting in Hitchin and beyond

Our fitters cover all of Hitchin, including SG5, SG4 and SG6, and travel on to Letchworth Garden City, Stevenage and Luton on the same basis. Nobody needs to visit us, because we come to the property for surveys and fitting. Dates are offered according to fitter availability, and travel is part of the written quote rather than an extra.

Planning and building control

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Questions about rooflight fitting in Hitchin

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

Do you make good inside after fitting?

Yes, where the quote includes it. Internal finishing usually means lining the reveal with plasterboard, taping or skimming, and fitting trim where it meets the ceiling. Some people prefer their own plasterer or decorator to finish off, which is fine. The written quote spells out exactly where our work stops, so nobody is left guessing about who does what once the unit is in.

Do you offer trade rates for builders and roofers?

We carry out subcontract fitting for builders, roofers, extension companies and commercial contractors. Pricing is per job or per schedule of units, agreed in writing before we start. We can work to your programme, fit on your upstand or build our own, and leave the opening ready for the next trade. Send drawings or a unit schedule and we will come back with a trade quote.

Does a rooflight need building regulations approval?

A new opening usually needs building regulations approval. A replacement is a controlled fitting: it must be self-certified by an installer registered with a competent person scheme or notified to building control. We are not registered with a scheme, so replacements we fit are notified to building control with a building notice, and the council's fee is shown on your quote.

Fitting jobs in Hitchin

Fitting & replacement

Flat roof rooflights

Pitched roofs & lofts

Commercial & trade

Why the fitting matters as much as the unit

Fitting in Hitchin and beyond

Planning and building control

Questions about rooflight fitting in Hitchin

Rooflight fitting in Hitchin