Walk-on rooflight installation across Oxfordshire

Guide prices in Oxfordshire

Up to 1 m²

£3,345 – £4,545including VAT at 20%

Laminated walk-on unit with anti-slip finish, fitted level with the terrace

Up to 2 m²

£4,545 – £7,195including VAT at 20%

Larger walk-on glazing

Large or bespoke

£7,195 – £11,995including VAT at 20%

Big panes, structural calculations, lifting gear

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Oxfordshire

Coverage in Oxfordshire works by postcode, not by distance from an office. Give us the full postcode and we will confirm whether it is standard cover, as it is for most of England, or one of the few remote and island areas handled by arrangement. Either way, you get a written quote before any work is booked, with travel included in the price.

Included in the work

Lifting plan for the unit, including people or gear for the day
Engineer's calculations and the unit's loading data checked together
Support frame or upstand prepared to the approved structural design
Structural calculations — We need structural calculations for the glass and its support before a walk-on job goes ahead.
Units tested to old standards — We check which standard the walk-on unit has been tested to.

Rules that apply in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Common questions in Oxfordshire

Does a rooflight need building regulations approval?

A new opening usually needs building regulations approval. A replacement is a controlled fitting: it must be self-certified by an installer registered with a competent person scheme or notified to building control. We are not registered with a scheme, so replacements we fit are notified to building control with a building notice, and the council's fee is shown on your quote.

Will my new walk-on rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

Walk-on rooflight installation in Oxfordshire