Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Gosport · PO12 · Hampshire

Walk-on rooflight installation in Gosport

Already bought a walk-on rooflight, or still deciding which one to get? Both are fine. For walk-on rooflight installation in Gosport we either source a suitable unit and install it, or fit the one waiting in your garage. Fit-only jobs are usually priced from your photos and measurements, while supply-and-fit and replacement jobs get a free survey first. Whichever route you take, the opening, the upstand or flashing, and the delivery are checked before anything is fixed down. Properties in PO12 and the surrounding districts are covered on the same terms.

Guide price from £3,345 · Supply & fit

Guide prices

Up to 1 m²

£3,345 – £4,545including VAT at 20%

Laminated walk-on unit with anti-slip finish, fitted level with the terrace

Up to 2 m²

£4,545 – £7,195including VAT at 20%

Larger walk-on glazing

Large or bespoke

£7,195 – £11,995including VAT at 20%

Big panes, structural calculations, lifting gear

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Fitting across Gosport and nearby

Jobs across PO12, PO1 and PO5 are part of our normal cover for Gosport. We are not an office on the high street. Our fitting teams come out to the property from wherever they are working that week. Neighbouring places such as Portsmouth and Southsea are covered on the same terms, so a house on the edge of town is no harder to book than one in the centre.

Your walk-on rooflights or ours

There are two ways to do this. Supply and fit means we source a walk-on rooflight that suits your roof and install it, so one company answers for both the product choice and the fitting. Fit-only means you buy the unit and we install it. With fit-only, the product warranty stays with the maker or seller, and our written guarantee covers the fitting work. Both routes get the same checks on the opening, the upstand and the maker's instructions before anything is fixed.

What we do on the day

  • Unit bedded and fixed so it sits level with the finished surface
  • Drainage around the unit checked so water does not lie on the glass
  • Perimeter joints sealed and the waterproofing lapped as the maker shows
  • Units tested to old standards — We check which standard the walk-on unit has been tested to.
  • Non-fragile is not walk-on — We make sure the unit is genuinely designed for foot traffic.

From arrival to clean-up

Morning first: the team arrives, introduces itself and walks through the job with you. Dust sheets go down in the room below and along the route in. Then the opening and upstand, or the flashing on a pitched roof, are checked against the unit's measurements. A walk-on rooflight goes in, is fixed to the maker's pattern and sealed into the roof covering. Inside, the reveal is finished as quoted. Before leaving, the team clears debris and talks you through what was done. Most jobs of this type take one to two days.

Regulations for Gosport properties

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Before you get in touch

A fast quote needs five things: a photo of the roof from outside, one from the room below, rough sizes of the opening or the space, the roof covering (felt, single-ply, fibreglass, tiles, slate or metal), and a note on access. If you have already bought the unit, add the product link or spec sheet. And give us the postcode, PO12 or a neighbouring district.

Common questions in Gosport

Do you offer trade rates for builders and roofers?

We carry out subcontract fitting for builders, roofers, extension companies and commercial contractors. Pricing is per job or per schedule of units, agreed in writing before we start. We can work to your programme, fit on your upstand or build our own, and leave the opening ready for the next trade. Send drawings or a unit schedule and we will come back with a trade quote.

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Tell us your postcode, PO12 or close by, and what you want fitted. We will reply with the next steps and a quote.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Walk-on rooflights in Gosport

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote