Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Welling · DA16 · Greater London

Walk-on rooflight installation in Welling

Already bought a walk-on rooflight, or still deciding which one to get? Both are fine. For walk-on rooflight installation in Welling we either source a suitable unit and install it, or fit the one waiting in your garage. Fit-only jobs are usually priced from your photos and measurements, while supply-and-fit and replacement jobs get a free survey first. Whichever route you take, the opening, the upstand or flashing, and the delivery are checked before anything is fixed down. Properties in DA16 and the surrounding districts are covered on the same terms.

Guide price from £3,345 · Supply & fit

Guide prices in Welling

Up to 1 m²

£3,345 – £4,545including VAT at 20%

Laminated walk-on unit with anti-slip finish, fitted level with the terrace

Up to 2 m²

£4,545 – £7,195including VAT at 20%

Larger walk-on glazing

Large or bespoke

£7,195 – £11,995including VAT at 20%

Big panes, structural calculations, lifting gear

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Covering DA16 and neighbouring districts

Covering Welling means covering the people who live and work there, not a single postcode. We take on domestic and commercial jobs in DA16, DA6 and DA15, and are happy to quote further out in Abbey Wood and Plumstead. If your address sits between towns, tell us and we will confirm whether it falls in our normal area or needs travel set out separately on the quote.

Fit-only or supply and fit

A damaged delivery is a frequent snag on fit-only work. Before the day, unpack a walk-on rooflight, photograph it, and tell the seller about any cracks or scuffs, because claims are much easier made early. We will also ask for the model or a link, so we can read the maker's instructions and check the builder's opening size and the upstand height it expects. If everything lines up, we fit it. If not, we explain what needs changing first.

What the job includes

  • Unit bedded and fixed so it sits level with the finished surface
  • Support frame or upstand prepared to the approved structural design
  • Perimeter joints sealed and the waterproofing lapped as the maker shows
  • Drainage around the glass — We check how water will drain from the terrace around the unit.
  • Weight on delivery day — We plan the delivery and lift before booking any lifting gear or extra hands.

A typical installation day

Morning first: the team arrives, introduces itself and walks through the job with you. Dust sheets go down in the room below and along the route in. Then the opening and upstand, or the flashing on a pitched roof, are checked against the unit's measurements. A walk-on rooflight goes in, is fixed to the maker's pattern and sealed into the roof covering. Inside, the reveal is finished as quoted. Before leaving, the team clears debris and talks you through what was done. Most jobs of this type take one to two days.

Planning and building rules in England

Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so we notify replacements to building control with a building notice and put the council's fee on the quote.

Help us quote accurately

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in DA16, and we can price it.

Common questions in Welling

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

Can you fit a rooflight in winter or when it is raining?

Yes, within limits. Cold is less of a problem than wet, because membranes, primers and sealants need a dry surface to bond. We plan fitting days around the forecast and may move a date if heavy rain is due. If the roof has to be opened up, it is not left overnight without a temporary weather seal, so the room below stays dry while the work is finished.

Can you fit the walk-on rooflight I bought online?

Yes, fit-only is one of our core services. Send the product link or spec, photos of the roof and rough sizes, and we can usually price it from those. Before fitting we check the delivery for damage, which should be reported to the seller, plus the size against the builder's opening and the upstand height. The product warranty stays with the maker or seller, and our guarantee covers the fitting.

Get in touch with the details of your Welling property and we will explain what the job involves and what it costs.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Walk-on rooflights in Welling

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote