Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Bromsgrove · B61 · Worcestershire

Trade rooflight fitting in Bromsgrove

Plenty of rooflight trouble starts with a tape measure. Units are often sold by the builder's opening, meaning the hole in the roof, rather than the overall external size, and confusing the two leaves you with a frame that does not suit the opening. Before we fit any rooflight in Bromsgrove, we measure the opening, the upstand or kerb where there is one, and the finished roof level, then compare them with the maker's drawing. If something is out, you hear about it before the fitting day rather than on it. That single check keeps most jobs like this on track.

Guide price from £295 + VAT · Labour only, ex VAT for trade accounts

Guide prices

Per flat rooflight

£295 – £495plus VAT, trade rate

Fit a supplied unit to your prepared upstand, sealed and trimmed

Per roof lantern

£695 – £1,495plus VAT, trade rate

Assemble and glaze a supplied lantern on your upstand

Two-person day rate

£445 – £645plus VAT, trade rate

Fitting team for multi-unit or mixed work

Guide ranges for labour only, ex VAT for trade accounts. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Is your address covered?

Fitters travel to the job, so the address is what counts. In Bromsgrove that means postcode districts B61, B60 and B48, and the same teams can just as easily take on work in Redditch, about 5 miles away, or Droitwich at roughly 6 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.

Included in the work

  • Flat rooflights fitted, sealed and trimmed on your kerbs
  • Upstands built by us where you would rather not
  • Supplied units checked against your schedule before fitting
  • Deliveries and damage — We check delivered units against the schedule before fitting.
  • Upstand ready and to size — We ask for the upstands to be built to the maker's drawing before we arrive.

Fitting your rooflight, step by step

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix a rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Regulations for Bromsgrove properties

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we agree up front who notifies it. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Before you get in touch

Each detail you send takes a question off our list. Photos inside and out show the opening and the ceiling. Rough measurements tell us the unit size. The roof covering tells us how it will be sealed in. Access notes tell us whether a tower or scaffold is needed. A product link, if you have one, lets us check it against the opening. Your postcode, B61 or nearby, confirms travel.

Common questions in Bromsgrove

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

For trade fitting around B61, send the unit spec and site details for a written price.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Trade fitting in Bromsgrove

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote