Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Tewkesbury · GL20 · Gloucestershire

Trade rooflight fitting in Tewkesbury

Glass is heavy, and bigger units get heavy fast. Fitting a rooflight in Tewkesbury means planning how it travels from the delivery vehicle to the roof without chipping an edge or straining a back. Smaller units go up by hand with two fitters. Larger ones may need a hoist, a scaffold loading bay or a crane, and we tell you at quote stage if that applies. Once it is up, the fitting follows the maker's sequence: seat, fix, seal, finish. We take on work like this across Gloucestershire.

Guide price from £295 + VAT · Labour only, ex VAT for trade accounts

Guide prices in Tewkesbury

Per flat rooflight

£295 – £495plus VAT, trade rate

Fit a supplied unit to your prepared upstand, sealed and trimmed

Per roof lantern

£695 – £1,495plus VAT, trade rate

Assemble and glaze a supplied lantern on your upstand

Two-person day rate

£445 – £645plus VAT, trade rate

Fitting team for multi-unit or mixed work

Guide ranges for labour only, ex VAT for trade accounts. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Where our fitters travel

Fitters travel to the job, so the address is what counts. In Tewkesbury that means postcode districts GL20, GL19 and GL52, and the same teams can just as easily take on work in Cheltenham, about 7 miles away, or Gloucester at roughly 9 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.

Included in the work

  • A short note of anything we found that needs your attention
  • Upstands checked for size, height, level and square
  • Supplied units checked against your schedule before fitting
  • Who weathers the roof — We agree who turns the roof covering up the kerb before we book.
  • Deliveries and damage — We check delivered units against the schedule before fitting.

What happens on the day

Protection comes before tools. Floors, furniture and stairs get covered, and the ceiling below the opening is sheeted to catch dust. Up top, the fitters confirm the opening is square and the upstand or flashing suits what the maker specifies. Fixing follows, then weather-sealing into the membrane, felt or tiles. Only once the roof is tight do they turn to the internal reveal. Time on site for a rooflight: half a day to a day per unit, weather permitting.

Do you need permission in Tewkesbury?

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so on trade replacements we agree up front who notifies building control, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Getting a price from photos

Each detail you send takes a question off our list. Photos inside and out show the opening and the ceiling. Rough measurements tell us the unit size. The roof covering tells us how it will be sealed in. Access notes tell us whether a tower or scaffold is needed. A product link, if you have one, lets us check it against the opening. Your postcode, GL20 or nearby, confirms travel.

Common questions in Tewkesbury

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

What if my roof opening is the wrong size for the rooflight?

We find out before the fitting day, not on it. If the opening is slightly out, it can usually be adjusted by trimming or by packing out the upstand. If it is a long way off, the choice is between altering the opening and changing the unit. Bear in mind that rooflights are often sold by builder's opening size rather than external size, so check which one your measurement refers to.

How long does fitting take?

Fitting a rooflight into an existing, correctly sized opening is often a day's work. New openings take longer, because joists or rafters need trimming, an upstand or flashing has to be built or fitted, and the inside needs finishing. Large units that need lifting gear, and days lost to rain, can stretch things further. Your written quote gives a realistic estimate for your roof.

Builders and roofers in Tewkesbury: send the spec and the site address for a written trade price.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Trade fitting in Tewkesbury

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote