Trade rooflight fitting across Cheshire

Guide prices in Cheshire

Per flat rooflight

£295 – £495plus VAT, trade rate

Fit a supplied unit to your prepared upstand, sealed and trimmed

Per roof lantern

£695 – £1,495plus VAT, trade rate

Assemble and glaze a supplied lantern on your upstand

Two-person day rate

£445 – £645plus VAT, trade rate

Fitting team for multi-unit or mixed work

Guide ranges for labour only, ex VAT for trade accounts. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Towns we list in Cheshire

Coverage in Cheshire works by postcode, not by distance from an office. Give us the full postcode and we will confirm whether it is standard cover, as it is for most of England, or one of the few remote and island areas handled by arrangement. Either way, you get a written quote before any work is booked, with travel included in the price.

What the job includes

Roof lanterns assembled and glazed on your upstand
Supplied units checked against your schedule before fitting
A short note of anything we found that needs your attention
Building control sign-off — We agree with you how building control is handled before fitting.
Deliveries and damage — We check delivered units against the schedule before fitting.

Rules that apply in England

Two sets of rules matter in England. Planning: a rooflight on a house is normally permitted development if it projects no more than 0.15 m and stays below the highest part of the roof, but flats, listed buildings and Article 4 areas need checking. Building regulations: new openings need approval for the structure and energy performance, and a replacement is a controlled fitting. We are not registered with a competent person scheme, so on replacements we agree up front who notifies building control.

Common questions in Cheshire

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

Do you need scaffolding to fit a rooflight?

Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

Trade rooflight fitting in Cheshire