Sudbury guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Where our fitters travel
Sudbury and the districts around it, CO10, IP7 and IP29, all sit inside our working area. So does the ground between Sudbury and Colchester (13 miles), and on towards Haverhill (13 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
Included in the work
- Membrane splits at the upstand cut back and patched
- Rotten kerb sections replaced where the timber has gone soft
- Inside check of stains, frame drainage channels and the reveal
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
- Warranty and who fitted it — We ask who fitted the rooflight and when before working on it.
How a repair visit goes
Expect the visit to be mostly looking and testing. Dust sheets go down below the rooflight. The fitter checks seals and glass from inside, then gets up on the roof by ladder or tower. Minor jobs such as clearing a blocked drainage channel can often be dealt with there and then. Bigger work, like new flashing or a replacement sealed unit, is measured up and priced in writing afterwards.
Planning and building rules in England
In England, a new rooflight opening generally needs building regulations approval because the roof structure is altered and the glazing must meet energy rules: 2.2 W/m²K for a rooflight in an existing home, or 1.4 W/m²K (or WER Band B) for a roof window. Planning is often not needed on a house: permitted development covers rooflights that stand no more than 0.15 m proud of the roof slope and sit below the highest part of the roof. Flats, listed buildings and areas with an Article 4 direction are different, so we check your address first.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Sudbury
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
For a repair in Sudbury, start with photos and the postcode; we confirm the visit price before anything is booked.
