What the job costs in Maltby
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Covering S66 and neighbouring districts
Maltby and the districts around it, S66, S25 and DN12, all sit inside our working area. So does the ground between Maltby and Dinnington (3 miles), and on towards Conisbrough (5 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
What we do on the day
- Membrane splits at the upstand cut back and patched
- Lifted flashing or tape removed and renewed
- Rotten kerb sections replaced where the timber has gone soft
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
- Water lying against the kerb — We check whether rainwater sits against the upstand after it stops raining.
How a repair visit goes
A repair visit starts outside. The fitter looks at the roof around the unit for ponding, split membrane, loose flashing and failed sealant, then moves inside to check stains, the frame and the condensation channels. Where it helps, a controlled water test narrows down the entry point. Before leaving, they explain what they found and whether a small fix can be done within the agreed visit, or needs a separate written quote.
Regulations for Maltby properties
England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Maltby
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Do you charge for a leak investigation in Maltby?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
For a repair in Maltby, start with photos and the postcode; we confirm the visit price before anything is booked.
