Guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Coverage in and around Speke
Fitters travel to the job, so the address is what counts. In Speke that means postcode districts L24, L26 and L25, and the same teams can just as easily take on work in Halewood, about 1 mile away, or Garston at roughly 2 miles. Survey and fitting dates are offered according to fitter availability, and travel is built into the quote rather than added later.
On the day, we cover
- Failed sealant cut out, joints cleaned, dried and resealed
- Inside check of stains, frame drainage channels and the reveal
- Membrane splits at the upstand cut back and patched
- Leak or condensation — We work out whether the water is coming from outside or forming inside on cold glass.
- Warranty and who fitted it — We ask who fitted the rooflight and when before working on it.
How a repair visit goes
On arrival we agree access and protect the floor. Then a methodical check: glass for misting or cracks, seals for gaps, the frame for movement, the upstand and roof covering for splits or water lying against the kerb. If the cause is obvious and minor, it can usually be sorted as part of the visit. If not, you have the evidence and a priced repair plan, and the choice is yours.
Regulations for Speke properties
England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Speke
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Do you charge for a leak investigation in Speke?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
For a repair in Speke, start with photos and the postcode; we confirm the visit price before anything is booked.
