Bordon guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Where our fitters travel
Jobs across GU35, GU30 and GU33 are part of our normal cover for Bordon. We are not an office on the high street. Our fitting teams come out to the property from wherever they are working that week. Neighbouring places such as Alton and Haslemere are covered on the same terms, so a house on the edge of town is no harder to book than one in the centre.
Included in the work
- Rotten kerb sections replaced where the timber has gone soft
- Controlled water test where it helps pin down the entry point
- Membrane splits at the upstand cut back and patched
- Upstand height and condition — We measure the kerb and probe the timber for softness.
- Warranty and who fitted it — We ask who fitted the rooflight and when before working on it.
How a repair visit goes
On arrival we agree access and protect the floor. Then a methodical check: glass for misting or cracks, seals for gaps, the frame for movement, the upstand and roof covering for splits or water lying against the kerb. If the cause is obvious and minor, it can usually be sorted as part of the visit. If not, you have the evidence and a priced repair plan, and the choice is yours.
Planning, building control and Bordon
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Before booking a visit, send what you can: a photo of the ceiling or reveal where water shows, a photo of the rooflight from outside, the roof covering if you know it, and whether it is one rooflight or several. We use that to price the visit and to bring the right materials.
Common questions in Bordon
Will resealing fix my leaking rooflight?
Sometimes. If the sealant has simply aged and the flashing, upstand and glass are sound, a careful reseal on a dry day can solve it. If the real problem is ponding water, a low upstand or a perished membrane, fresh sealant will only hide it for a while. We tell you which one you are dealing with before recommending any work, and quote the proper fix in writing.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
Should I repair or replace my old leaking rooflight?
It depends on the age and condition of the unit and what has failed. A single perished seal or a blocked channel is worth repairing. A brittle, discoloured dome, a rotten kerb, or several faults at once usually make replacement the better value. After the diagnostic visit we set out both options with prices, so you can decide with the full picture in front of you.
Send photos of the problem in Bordon and we will price the visit before you book it.
