Guide prices
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Areas around Barrow-in-Furness we cover
Barrow-in-Furness and the districts around it, LA14, LA13 and LA15, all sit inside our working area. So does the ground between Barrow-in-Furness and Heysham (14 miles), and on towards Morecambe (15 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
On the day, we cover
- Lifted flashing or tape removed and renewed
- Inside check of stains, frame drainage channels and the reveal
- Controlled water test where it helps pin down the entry point
- Water lying against the kerb — We check whether rainwater sits against the upstand after it stops raining.
- Age of the rooflight — We weigh the age and condition of the unit before recommending a repair.
How a repair visit goes
Expect the visit to be mostly looking and testing. Dust sheets go down below the rooflight. The fitter checks seals and glass from inside, then gets up on the roof by ladder or tower. Minor jobs such as clearing a blocked drainage channel can often be dealt with there and then. Bigger work, like new flashing or a replacement sealed unit, is measured up and priced in writing afterwards.
Do you need permission in Barrow-in-Furness?
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Barrow-in-Furness
Will resealing fix my leaking rooflight?
Sometimes. If the sealant has simply aged and the flashing, upstand and glass are sound, a careful reseal on a dry day can solve it. If the real problem is ponding water, a low upstand or a perished membrane, fresh sealant will only hide it for a while. We tell you which one you are dealing with before recommending any work, and quote the proper fix in writing.
Why is my rooflight leaking?
The usual causes are sealant that has cracked or pulled away, flashing or membrane that has perished at the edges, condensation channels blocked with dirt, water ponding against the kerb, or a seal failing on the glass unit. Sometimes the water is coming in elsewhere and running along to the rooflight. A diagnostic visit finds the real source before anyone starts applying sealant.
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Send photos of the problem in Barrow-in-Furness and we will price the visit before you book it.
