Guide prices in Bedford
Diagnostic visit
Roof and inside inspected, cause found, written repair price
Reseal and re-flash
Failed sealant and flashing taken out, joints cleaned, resealed and taped
Upstand or membrane repair
Rotten kerb section or roof membrane at the upstand repaired
Guide ranges. The first visit is charged and priced before booking; any repair is priced in writing before work starts. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.
Covering MK40 and neighbouring districts
Bedford and the districts around it, MK40, MK42 and MK41, all sit inside our working area. So does the ground between Bedford and Kempston (2 miles), and on towards Ampthill (8 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.
On the day, we cover
- Controlled water test where it helps pin down the entry point
- Rotten kerb sections replaced where the timber has gone soft
- Outside inspection of glass, frame, sealant, flashing and roof covering
- Warranty and who fitted it — We ask who fitted the rooflight and when before working on it.
- Upstand height and condition — We measure the kerb and probe the timber for softness.
How a repair visit goes
On arrival we agree access and protect the floor. Then a methodical check: glass for misting or cracks, seals for gaps, the frame for movement, the upstand and roof covering for splits or water lying against the kerb. If the cause is obvious and minor, it can usually be sorted as part of the visit. If not, you have the evidence and a priced repair plan, and the choice is yours.
Planning and building rules in England
Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.
What to send us
Tell us where the water appears, how long it has been happening and what the weather was doing when it started. A couple of photos from inside and outside, plus the postcode, let us price the visit before you book and plan what the fitter brings.
Common questions in Bedford
Can you replace just the misted glass?
Often, yes. Misting between the panes means the sealed unit has failed, but the frame around it may be perfectly sound. Where the maker's design allows the glass to be changed, we measure the unit and fit a replacement, which costs less than a whole new rooflight. Where it does not, or the frame is also worn out, we explain why replacement is the better option.
Is it condensation or a leak?
Condensation tends to appear on cold mornings, on the inner face of the glass, and runs down the frame. A leak usually follows rain or wind from a particular direction and often stains the ceiling around the opening. Blocked condensation channels can make the two look alike. Photos and a note of when it happens help us narrow it down before the visit.
Do you charge for a leak investigation in Bedford?
Yes. Tracing a leak properly takes time on the roof, a close look at the frame and sometimes a water test, so the visit is charged. We confirm the price before you book, so there are no surprises. If a repair is needed beyond what can be done during the visit, it is quoted separately in writing and you decide whether to go ahead.
For a repair in Bedford, start with photos and the postcode; we confirm the visit price before anything is booked.
