Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Stoke-on-Trent · ST4 · Staffordshire

Flat rooflight installation in Stoke-on-Trent

Glass is heavy, and bigger units get heavy fast. Fitting a flat rooflight in Stoke-on-Trent means planning how it travels from the delivery vehicle to the roof without chipping an edge or straining a back. Smaller units go up by hand with two fitters. Larger ones may need a hoist, a scaffold loading bay or a crane, and we tell you at quote stage if that applies. Once it is up, the fitting follows the maker's sequence: seat, fix, seal, finish. We take on work like this across Staffordshire.

Guide price from £995 · Supply & fit

Guide prices

Small fixed

£995 – £1,495including VAT at 20%

Double-glazed fixed unit up to 1000 × 1000 mm, fitted to a ready upstand

Medium fixed

£1,495 – £2,295including VAT at 20%

1000 × 1500 to 1000 × 2000 mm, double or triple glazed

Large fixed

£2,295 – £4,095including VAT at 20%

Bigger units, solar-control glass, two-person lift or lifting gear

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Is your address covered?

Covering Stoke-on-Trent means covering the people who live and work there, not a single postcode. We take on domestic and commercial jobs in ST4, ST1 and ST5, and are happy to quote further out in Newcastle-under-Lyme and Longton. If your address sits between towns, tell us and we will confirm whether it falls in our normal area or needs travel set out separately on the quote.

Your flat rooflights or ours

Which works out better, buying your own or letting us supply? It depends on what you value. Buying your own gives you control of the product and what you pay for it. Letting us supply puts the whole job, unit and fitting, under one written quote. On a customer-supplied unit we still measure it against the opening, look at the upstand, and inspect the condition it arrived in. Warranty on the product sits with whoever sold it, while the fitting carries our own guarantee.

What the job includes

  • Upstand checked or built to the maker's internal and external sizes
  • Fall confirmed so rain runs off the glass rather than sitting on it
  • Membrane, felt or GRP finished to the frame the way the maker shows
  • Ceiling and reveal depth — We measure the depth from the kerb top to the ceiling to plan the reveal.
  • Pitch of the glass — We make sure the glass will sit at the pitch its maker asks for.

From arrival to clean-up

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix a flat rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Planning, building control and Stoke-on-Trent

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Getting a price from photos

What we cannot see, we have to guess, and guesses make quotes wider. So the more you send, the tighter the price. Useful: shots from the roof or garden, shots from the room underneath, a rough width and length, the roof finish, any access problems, and the product page if you have already ordered. Add the property postcode around ST4 and we will come back with a quote or a survey date.

Common questions in Stoke-on-Trent

How long does fitting take?

Fitting a flat rooflight into an existing, correctly sized opening is often a day's work. New openings take longer, because joists or rafters need trimming, an upstand or flashing has to be built or fitted, and the inside needs finishing. Large units that need lifting gear, and days lost to rain, can stretch things further. Your written quote gives a realistic estimate for your roof.

Can you fit a rooflight in winter or when it is raining?

Yes, within limits. Cold is less of a problem than wet, because membranes, primers and sealants need a dry surface to bond. We plan fitting days around the forecast and may move a date if heavy rain is due. If the roof has to be opened up, it is not left overnight without a temporary weather seal, so the room below stays dry while the work is finished.

Can you fit the flat rooflight I bought online?

Yes, fit-only is one of our core services. Send the product link or spec, photos of the roof and rough sizes, and we can usually price it from those. Before fitting we check the delivery for damage, which should be reported to the seller, plus the size against the builder's opening and the upstand height. The product warranty stays with the maker or seller, and our guarantee covers the fitting.

For a free, no-obligation quote in Stoke-on-Trent, use the form or call us with the details of your roof.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Flat rooflights in Stoke-on-Trent

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote