Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Wigan · WN1 · Greater Manchester

Flat rooflight installation in Wigan

If the flat rooflight on your roof now is misted, discoloured, cracked or letting water in, replacing it is often simpler than people expect. The old unit comes out, we inspect the kerb or frame underneath, and we decide with you whether it can be reused or needs rebuilding. Then the new one goes in, sealed to the roof covering and finished inside. We handle this kind of flat rooflight installation in Wigan and nearby, alongside new openings and fit-only work. Postcode WN1 and its neighbours are all within our cover.

Guide price from £995 · Supply & fit

Guide prices in Wigan

Small fixed

£995 – £1,495including VAT at 20%

Double-glazed fixed unit up to 1000 × 1000 mm, fitted to a ready upstand

Medium fixed

£1,495 – £2,295including VAT at 20%

1000 × 1500 to 1000 × 2000 mm, double or triple glazed

Large fixed

£2,295 – £4,095including VAT at 20%

Bigger units, solar-control glass, two-person lift or lifting gear

Guide ranges for supply & fit. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Areas around Wigan we cover

Covering Wigan means covering the people who live and work there, not a single postcode. We take on domestic and commercial jobs in WN1, WN3 and WN5, and are happy to quote further out in Hindley and Ashton in Makerfield. If your address sits between towns, tell us and we will confirm whether it falls in our normal area or needs travel set out separately on the quote.

Already bought your unit?

Supply and fit tends to suit people who would rather not pick a unit from a catalogue. We look at the roof, the opening and how you use the room, then put a flat rooflight on the quote that fits all three. Fit-only suits people who already know what they want, or have one on site. We are happy with either. The difference is who stands behind what: on fit-only, the maker or retailer covers the product, and our workmanship guarantee covers the installation.

On the day, we cover

  • Unit bedded on the specified sealant or tape and screw-fixed
  • Membrane, felt or GRP finished to the frame the way the maker shows
  • Fall confirmed so rain runs off the glass rather than sitting on it
  • Pitch of the glass — We make sure the glass will sit at the pitch its maker asks for.
  • Weight of large panes — We check the weight of the unit against how we will get it onto the roof.

What happens on the day

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix a flat rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Planning, building control and Wigan

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Help us quote accurately

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in WN1, and we can price it.

Common questions in Wigan

What upstand height and roof pitch does flat rooflight fitting need?

It depends on the product. Manufacturers usually specify a minimum upstand height above the finished roof surface, and a minimum pitch on the glass so rain runs off. We follow the maker's figures for your unit rather than a rule of thumb. If your existing kerb or roof falls short, we explain the options, such as raising the upstand or choosing a unit with built-in pitch.

Do I need planning permission for a rooflight in Wigan?

Often not. Many rooflights fall under permitted development, provided they do not project beyond the national limit and meet the other conditions that apply in England. Conservation areas, listed buildings and some flats are different and may need consent. Because the rules depend on the property, we confirm what is likely to apply at your address and point you to the planning authority where an application is needed.

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Got a unit waiting to go in, or need one sourced? Either way, start with your Wigan address and a couple of photos.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Flat rooflights in Wigan

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote