Electric opening rooflight installation in Swindon

Guide prices in Swindon

Guide ranges for supply & fit; the electrician's final connection is quoted separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Covering SN1 and neighbouring districts

Covering Swindon means covering the people who live and work there, not a single postcode. We take on domestic and commercial jobs in SN1, SN2 and SN3, and are happy to quote further out in Calne and Cirencester. If your address sits between towns, tell us and we will confirm whether it falls in our normal area or needs travel set out separately on the quote.

What we check on a supplied unit

A damaged delivery is a frequent snag on fit-only work. Before the day, unpack an electric opening rooflight, photograph it, and tell the seller about any cracks or scuffs, because claims are much easier made early. We will also ask for the model or a link, so we can read the maker's instructions and check the builder's opening size and the upstand height it expects. If everything lines up, we fit it. If not, we explain what needs changing first.

Included in the work

• Wall switch, remote receiver or control box fixed in place
• Unit fitted, sealed and weathered like a fixed flat rooflight
• Rain sensor positioned where it will get wet when rain starts
• Opening onto a side slope — We check where the opening part will sit if the roof is pitched or the unit faces a neighbour.
• Cable length and size — We check the cable run against the maker's limits before planning where the controls go.

Fitting your electric opening rooflight, step by step

Morning first: the team arrives, introduces itself and walks through the job with you. Dust sheets go down in the room below and along the route in. Then the opening and upstand, or the flashing on a pitched roof, are checked against the unit's measurements. An electric opening rooflight goes in, is fixed to the maker's pattern and sealed into the roof covering. Inside, the reveal is finished as quoted. Before leaving, the team clears debris and talks you through what was done. Most jobs of this type take one day, plus the electrician's connection.

Planning and building rules in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

What to send for a quick quote

Keep it simple. Two or three photos, outside and inside. Approximate sizes. What the roof is made of. Anything awkward about getting up there, such as a conservatory below, a narrow side path or no parking. If you bought the rooflight online, the link or model name. Then your postcode in or around SN1. That is enough for a first price.

Common questions in Swindon

Tell us your postcode, SN1 or close by, and what you want fitted. We will reply with the next steps and a quote.