Electric opening rooflight installation in Bentley

Guide prices in Bentley

Guide ranges for supply & fit; the electrician's final connection is quoted separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Covering DN5 and neighbouring districts

Distance is rarely the deciding factor. A roof in Doncaster, 1 mile from Bentley, gets the same survey, the same written quote and the same fitting process as one in DN5, DN1 and DN2. What changes the price is the job itself: size of unit, roof type, access and lifting. Adwick le Street, around 3 miles out, is treated the same way.

Buying your own, or letting us supply

A damaged delivery is a frequent snag on fit-only work. Before the day, unpack an electric opening rooflight, photograph it, and tell the seller about any cracks or scuffs, because claims are much easier made early. We will also ask for the model or a link, so we can read the maker's instructions and check the builder's opening size and the upstand height it expects. If everything lines up, we fit it. If not, we explain what needs changing first.

Included in the work

• Wall switch, remote receiver or control box fixed in place
• Upstand checked or built to suit the unit and its actuator housing
• Cable route planned through the kerb or reveal before the lining goes on
• Cable length and size — We check the cable run against the maker's limits before planning where the controls go.
• Where power comes from — We find a sensible power supply for the rooflight before fitting day.

From arrival to clean-up

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix an electric opening rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Planning, building control and Bentley

England's rules in short: permitted development usually covers a rooflight on a house roof provided it doesn't stick out more than 0.15 m or rise above the ridge, though a listed building always needs consent and some streets have Article 4 directions. Building regulations apply to new openings, and replacements go through building control; as we are not registered with a competent person scheme, we use a building notice and show the fee on the quote. The energy limit for rooflights in existing homes is 2.2 W/m²K, and the 2026 Approved Document L, in force from 24 March 2027, keeps that figure.

Before you get in touch

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in DN5, and we can price it.

Common questions in Bentley

For a free, no-obligation quote in Bentley, use the form or call us with the details of your roof.