Fit-onlySupply & fitReplacementsTrade fitting
Fitting teams across England, Wales, Scotland & NI · Call 0800 088 6248
RooflightInstallers.co.uk
Ramsbottom · BL0 · Greater Manchester

Electric opening rooflight installation in Ramsbottom

Builders and extension firms in Ramsbottom often want the rooflight stage of a project handled by a specialist fitting team. We step in once the roof deck or battens are ready, fit an electric opening rooflight on your upstand or ours, detail it into the membrane or tiles, and leave the opening ready for the plasterer. Homeowners get exactly the same service directly. In each case the job is quoted in writing first, with any access or lifting needs spelt out. Jobs around BL0 and the neighbouring districts are welcome.

Guide price from £2,645 · Supply & fit; the electrician's final connection is quoted separately

Guide prices

Small opening

£2,645 – £3,595including VAT at 20%

Up to about 1000 × 1000 mm with actuator, rain sensor and switch or remote

Medium opening

£3,595 – £4,795including VAT at 20%

Larger units, wall switch and remote

Large opening

£4,795 – £6,945including VAT at 20%

Big or heavy units, extra actuators

Guide ranges for supply & fit; the electrician's final connection is quoted separately. Your price is fixed in a written quote after we have seen photos or surveyed. Scaffold, access towers or a crane are priced separately if the job needs them, and building control fees, where a job needs them, are shown as their own line.

Where our fitters travel

Ramsbottom and the districts around it, BL0, BL8 and BL9, all sit inside our working area. So does the ground between Ramsbottom and Bury (3 miles), and on towards Haslingden (4 miles). When a fitting team is booked, their travel is already in the quoted price, so it does not turn up as a surprise line on the final bill.

Buying your own, or letting us supply

If you have bought an electric opening rooflight yourself, we check four things before fitting. First, the delivery: open it, look for chips, cracks and bent frames, and report any damage to the seller straight away. Second, the size, measured against the builder's opening rather than the external frame. Third, the upstand height above the finished roof. Fourth, the maker's instructions, which set the fixings and sealing. Product warranty claims go to the seller and maker; our guarantee is for how it was fitted.

Included in the work

  • Cable route and controls set up ready for the electrician's final connection, quoted as a separate line
  • Wall switch, remote receiver or control box fixed in place
  • Cable route planned through the kerb or reveal before the lining goes on
  • Rain sensor position — We place the rain sensor where rain will reach it quickly and debris will not cover it.
  • Opening onto a side slope — We check where the opening part will sit if the roof is pitched or the unit faces a neighbour.

How a fitting day runs

On the day, you need to be in at the start and at the end. In between, the fitters get on with it. They will want the room below cleared where possible, a parking spot if you have one, and somewhere to set the unit down safely. After checking the opening and the upstand or flashing, they fix an electric opening rooflight, seal it and finish the inside. Packaging and any old unit leave with them unless the quote says otherwise.

Planning and building rules in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Before you get in touch

Start with your phone. Take a picture of the roof where the unit goes or already sits, then one from inside looking up. Measure what you can, even roughly. Tell us what the roof is covered with and how a fitter would reach it: ladder, garden access or scaffold. Bought it already? Send the link or spec. Add your full postcode, for example in BL0, and we can price it.

Common questions in Ramsbottom

Can you remove and dispose of the old rooflight?

Yes. Taking out the old unit is part of any replacement job, and it leaves with the rest of the waste unless you ask to keep it. Old domes, glass and frames go through proper waste routes. If removal turns up a rotten kerb or damaged decking, we show you what we have found and agree the repair with you before going any further.

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Do you cover Ramsbottom?

Yes. Fitters travel to addresses in Ramsbottom and the surrounding districts, including BL0. We do not run an office there; the survey and the fitting happen at your property. A few island and remote postcodes are covered by arrangement; if yours is one, we confirm travel and dates before quoting.

Planning an electric opening rooflight in Ramsbottom? Tell us about the roof and we will come back with a clear price in writing.

Rear extension at dusk with lit rooflights and a roof lantern
Ready when you are

Electric opening in Ramsbottom

Send photos and rough sizes, or ask for a survey for install work. One fixed written price before anything starts.

CallGet a quote