Rooflight installers in Peckham

Fitting jobs in Peckham

Why the fitting matters as much as the unit

Builders run many trades at once, and the rooflight often gets squeezed in between the roofer and the plasterer. That is when corners get cut: an upstand built a little low, sealant applied in damp conditions, a reveal left rough. Bringing in a fitting specialist for that one stage means someone is focused on it alone, following the maker's instructions, with time set aside to finish the inside properly. The builder keeps control of the programme, and the rooflight gets proper attention.

Is your Peckham address covered?

We do not run a branch in Peckham. What we do is send fitting teams to the job, which means SE15, SE5 and SE14 are covered, and so are Camberwell, New Cross and Brockley. The advantage for you is simple: you deal with one company for the quote, the fitting and the guarantee, wherever the property sits.

Planning and building control

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Questions about rooflight fitting in Peckham

Do you offer trade rates for builders and roofers?

We carry out subcontract fitting for builders, roofers, extension companies and commercial contractors. Pricing is per job or per schedule of units, agreed in writing before we start. We can work to your programme, fit on your upstand or build our own, and leave the opening ready for the next trade. Send drawings or a unit schedule and we will come back with a trade quote.

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

How long does fitting take?

Fitting a rooflight into an existing, correctly sized opening is often a day's work. New openings take longer, because joists or rafters need trimming, an upstand or flashing has to be built or fitted, and the inside needs finishing. Large units that need lifting gear, and days lost to rain, can stretch things further. Your written quote gives a realistic estimate for your roof.

Do you make good inside after fitting?

Yes, where the quote includes it. Internal finishing usually means lining the reveal with plasterboard, taping or skimming, and fitting trim where it meets the ceiling. Some people prefer their own plasterer or decorator to finish off, which is fine. The written quote spells out exactly where our work stops, so nobody is left guessing about who does what once the unit is in.

Fitting jobs in Peckham

Fitting & replacement

Flat roof rooflights

Pitched roofs & lofts

Commercial & trade

Why the fitting matters as much as the unit

Is your Peckham address covered?

Planning and building control

Questions about rooflight fitting in Peckham

Rooflight fitting in Peckham