Rooflight installers in Kingston upon Thames

Fitting jobs in Kingston upon Thames

Why the fitting matters as much as the unit

Product warranties on rooflights usually depend on the unit being fitted to the maker's instructions. Those instructions cover upstand height, fixing centres, sealants, and how the roof covering is dressed in. Following them line by line takes familiarity with how different units go together. A specialist fitter reads the paperwork, checks the delivery and measures the opening before starting, then fits to the book. If something on site does not match, they flag it rather than improvising. That protects both the roof and the warranty.

Nearby towns we also cover

Postcodes KT1, KT2 and KT5 are the core of our Kingston upon Thames coverage, but they are not the boundary. Addresses in Surbiton, New Malden and East Molesey are handled in just the same way, with fitters travelling to each one and travel costs built into the quote before you agree to anything. If you are unsure which side of a boundary you fall on, the full postcode settles it.

Planning and building rules in England

Replacing a rooflight in an English home is a controlled fitting: it has to be self-certified by a scheme-registered installer or notified to building control. We are not registered with a competent person scheme, so replacements we fit are notified with a building notice, and the new unit has to meet current energy limits. Adding a new one usually means a building regulations application, because joists or rafters are trimmed. On the planning side, most house rooflights are permitted development if they project 0.15 m or less; on a side slope the glass must be obscured and fixed unless the opening part is over 1.7 m above the floor.

Questions about rooflight fitting in Kingston upon Thames

How does payment work?

Payment terms are set out on your written quote before you accept it. Depending on the job, that may mean a deposit, stage payments for larger work, or payment on completion. The contract is with S&K Property Investments and Improvement Ltd, part of the S&K Group. Nothing is added without your agreement: if something unexpected comes up, we discuss it and agree any change before carrying on.

Will my new rooflight leak?

A correctly fitted unit should not. Leaks usually trace back to the detail around the frame: an upstand that is too low, a membrane or flashing that is not dressed properly, sealant applied to a damp surface, or water ponding against the kerb. We fit to the maker's instructions and check each of those points. The fitting carries a written workmanship guarantee, with its terms set out on your quote.

Do you need scaffolding to fit a rooflight?

Not always. Single-storey roofs can often be reached safely with ladders, a tower or edge protection. Higher roofs, steep pitches and large units usually need scaffold or a mobile platform, and heavy glass may need a crane. We assess access from your photos or at the survey, and any scaffold or lifting cost is shown as its own line on the written quote.

Can you replace an old dome without redoing the whole roof?

Usually, yes. If the existing kerb is sound, level and tall enough, a new unit can often sit on it with a fresh seal to the roof covering. If the kerb is rotten or too low, we rebuild it and patch the covering around it rather than stripping the whole roof. This is checked at the survey and included in the written quote, so you know the full scope first.

Rooflight installers in Kingston upon Thames

Fitting jobs in Kingston upon Thames

Fitting & replacement

Flat roof rooflights

Pitched roofs & lofts

Commercial & trade

Why the fitting matters as much as the unit

Nearby towns we also cover

Planning and building rules in England

Questions about rooflight fitting in Kingston upon Thames

Rooflight fitting in Kingston upon Thames